XF-20B卧式沸腾干燥机

洁净的热风经阀板分配进入床体内，从加料器进入的湿物料被热风形成流化状态，如煮沸的开水在床体内跳跃，故称为沸腾干燥器（或机），由于热风与物料广泛接触，因此在较短的时间内就可以干燥。从床体的一头进入，经几分钟至几十分钟时间的“沸腾”，从床体的另一头自动流出。
Clean hot air enters into fluidization bed through distributor of valve plate. Wet materials comes from feeder will be formed a fluidization state by hot air(jumping within the bed like boiling water), so it is called fluidizing dryer.Because of the large contacting area between hot air and materials, the drying time is very short.The air enters from one end of bed, through “boiling” several minutes, and then comes out automatically from the other end.

沸腾床、旋风分离器及布袋除尘器安放在平整的水泥地平上即可，不需底脚螺丝。风机可安装在室内或室外，需有底座及地脚螺丝。平面布置可根据厂房情况酌情调整。
风道系统应不漏气，以免影响干燥效果。
Fluidizing bed, cyclone separator and bag dust remover should be placed on the flat concrete ground, and no foundation screw is needed. The fan with underframe and foundation screws could be installed indoor or outdoors,The plan can be adjusted slightly in accordance with the particle conditions.

No air should leak in air pipe system to be free from the influence on drying efficiency.